The following schedule has been developed to help you get a new pond (or newly cleaned pond) off to a good start - aiming to achieve a natural balance, and as a result, clear water. A pond will turn green, foamy, and have an odor in the first 90 days. To add water in chloramine areas put
hose in bottom of pond and add water slowly. The purpose of this chart is to control the balance setup, not stop it. NOTE: Read instructions in the catalog for all chemicals you have purchased. Be aware of their capabilities and limitations.
| Cutrine Pond Setup Chart |
|
Note: |
Use for ponds over 25,000 gallons. |
|
DAY
|
PROCEDURE
|
| Day 1 |
A. Use 2 oz. Quick Start per 100 gallons of pond water.
B. Float fish and snails for 30 minutes, then release.
C. Add 1 pound of Water Clarifier per 100 gallons of pond water.
D. Add 1/4-pound Formulated Fish Salts per 100 gallons of pond water.
E. Add 1 oz. Fish Stabilizer per 100 gallons of pond water.
F. Plant and install the recommended amounts of:
1) Oxygenating Grasses 2) Water Lilies
3) Bog Plants 4) Ornamental Grasses. |
| Day 5 |
A. Add 1-pound Water Clarifier per 100 gallons of pond water.
B. Add 1/4-pound Formulated Fish Salts per 100 gallons of pond water.
C. Add 1 oz. Fish Stabilizer per 100 gallons of pond water. |
| Day 10 |
Mix 1/8 teaspoon Cutrine-Plus per 100 gallons of pond water in one quart water. Mix well and spray solution on 1/2 the pond’s surface, being careful not to spray plant foliage. Note: One-quart hand sprayers available at Gardens are recommended. |
|
Day 11 |
Repeat Cutrine-Plus treatment on second 1/2 of pond’s surface |
|
Day 12 |
Repeat Cutrine-Plus treatment on first 1/2 of pond’s surface. |
|
Day 14 |
Repeat Cutrine-Plus treatment on second 1/2 of pond. |
|
Day 15 |
Repeat Cutrine-Plus treatment on second 1/2 of pond. |
|
Day 17 |
Feed fish as much as they will eat in ten minutes (approximately one tablet per fish.)
Note: Overfeeding fish adds excess nitrogenous wastes to pond, fertilizing algae and endangering the health of your fish. |
|
Day 20 |
A. Repeat Cutrine-Plus treatment of first 1/2 pond’s surface, increasing dosage to 3/8 teaspoon per 100 gallons of pond water.
B. Inspect containers to insure plants are still planted properly. Note: When underwater the soil will often pack, exposing rooting areas of aquatic plants. Also, if oxygenating grasses are floating, they will have to be replanted and a 6-inch wire mesh dome
placed over the container to prevent the fish from eating them while they root. |
|
Day 24 |
Feed fish as before. |
|
Day 27 |
Repeat Cutrine-Plus treatment on second 1/2 of pond’s surface using 3/8-teaspoon per 100 gallons of pond water. |
|
Day 31 |
Feed fish as before. |
|
Day 34 |
Repeat Cutrine-Plus treatment of first 1/2 of pond’s surface using the 3/8-teaspoon per 100 gallons of pond water. |
|
Day 38 |
Feed fish as before. |
|
Day 41 |
Remove cap from Cutrine-Plus bottle and place ten inches below pond water surface. If cap is clearly visible, continue Cutrine-Plus treatment using 3/8 teaspoon per 100 gallons of pond water on second 1/2 of pond’s surface. Continue with treatment schedule going
on to day 45. If view of cap is clouded, return to day 1 and start again deleting Salt, Stabilizer and Quick Start. |
|
Day 45 |
Feed fish as before. |
|
Day 47 |
Repeat Cutrine-Plus treatment using 3/8-teaspoon per 100 gallons pond water, spraying first 1/2 of pond’s surface. |
|
Day 52 |
Feed fish as before. |
|
Day 54
|
Cutrine-Plus treatment using 3/8-teaspoon per 100 gallons of pond water, spraying second 1/2 of pond’s surface. |
|
Day 59
|
Feed fish as before.
At this time the pond will start to balance the control itself. It is important to continue chemical treatments as needed -at least once a month. Avoid the temptation to overfeed your fish. If the pond water is not clear, check the oxygenating grasses, replacing
or replanting as needed. Refer to monthly chart. |
|
Note: |
Amounts required to complete chart: 2 lbs. Clarifier/100 gal.; 2 drops Fish Stabilizer/100 gal.; 1/2 lb. Formulated Fish Salts/100 gal.; 8 oz. Cutrine-Plus for ponds up to 5,000 gal.; 16 oz. Cutrine-Plus for ponds over 5,000 gal.; 2 oz. Quick Start per 100 gal. |
